Prg Vx76 User Manual 3.6 Bedienungsanleitung PDF herunterladen (Seite 83)

VX76 SOFTWARE USER MANUAL 67

Dynamics

When [Dynam] is selected, the soft encoder mapping is as follows:

RATE (5 sec / +1 sec)

w/ [Shift] button pressed - RATE (5 sec / -1 sec)

w/ [Fan] button pressed - RATE (5 sec / fan +1 sec)

This encoder changes the rate of a dynamic on parameters selected in the Filter window. CCW speeds up

the rate, while CW slows the rate down. The rate can also be fanned.

SIZE (default / autoFit)

This encoder changes the size of a dynamic on parameters selected in the Filter window. CCW decreases

the size, while CW increases the size. The size can also be fanned.

autoFit - automatically chooses the maximum size dynamic.

OFFSET (min / +120)

w/ [Shift] button pressed - OFFSET (min/-180)

w/ [Fan] button pressed - OFFSET (min/fan +180)

This encoder is used to determine where along the waveform, the dynamic should start. The Offset is

measured in degrees where a complete waveform is 360 degrees (1 cycle). This function can be used to

create "multi" looks when the offset is fanned across channels. (Note that the minimum is 0 degrees.)

Refer to the "Dynamics" chapter on page 149 for more information about using the encoders with dynamics.

Frame

When [Frame] is selected, the soft encoder mapping is as follows:

ROTATE

[mid] - sends framing mechanism back to its mid-point.

[rot 90] - rotates framing mechanism 90 degrees from its current position.

ALL

[flip H] - flips framed image to a horizontal position.

[flip V] - flips framed image to a vertical position.

SHUTTER 4

Button [max] selects Encoder 4 and controls both motors to bring the shutter in.

Button [min] selects Encoder 4 and controls both motors to take the shutter out.

SHUTTER 3

Button [max] selects Encoder 3 and controls both motors to bring the shutter in.

Button [min] selects Encoder 3 and controls both motors to take the shutter out.

SHUTTER 2

Button [max] selects Encoder 2 and controls both motors to bring the shutter in.

Button [min] selects Encoder 2 and controls both motors to take the shutter out.

SHUTTER 1

Button [max] selects Encoder 1 and controls both motors to bring the shutter in.

Button [min] selects Encoder 1 and controls both motors to take the shutter out.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 417 418

Keine Kommentare

Prg Vx76 User Manual 3.6 Bedienungsanleitung Seite 83